ULTRAFINE CEMENTITIOUS GROUT

grouting project icons grout project icons

Mixing Instructions for Cementitious Grout Formulations

 

US Grout’s cementitious grout products should be mixed in a high-shear mixer having a rotor speed of approximately 1800 rpm and should be kept in motion until injected.

PHOTO

Mixing US Grout Ultrafine VX in a high-shear mixer.

Mixing Procedures

(See end sticker on grout bag for TYPE DESIGNATION)

TYPE SD GROUT

1. Meter water into mixer.

2. Add dry grout.

3. Mix at full speed for three minutes.

4. Discharge from mixer.

TYPE VX GROUT

1. Meter water into mixer.

2. Add dry grout.

3. Mix at full speed for three minutes.

4. Discharge from mixer.

NOTE: This grout is thixotropic and should be KEPT IN MOTION until injected.

CAUTION: Although this grout is non-hazardous and environmentally friendly, it contains Portland cement. Exposure to wet grout can cause irritation of eyes and skin. Skin contact should be washed with water. If wet grout or dry grout dust comes in contact with the eyes, they should be flushed with copious amounts of water for at least 5 minutes.

Expert Support

As the world-wide distributor for US Grout products, Avanti International (www.avantigrout.com • 1-800-877-2570) provides the customer service, objective professional advice, material estimates, and the caliber of world-class technical support that comes only from over 35 years of geotechnical experience.

return to top

PHOTO

Mixing US Grout Ultrafine VX in a high-shear mixer.

SALES AND SUPPORT

Avanti International:
1.800.877.2570 or
1 281.486.5600

822 Bay Star Blvd.,
Webster, TX 77598

compass rose

SITE MAP