SITE MAP

US Grout Logo

Mixing Instructions for US Grout Cementitious Grout Formulations

These cementitious grout products should be mixed in a high-shear mixer having a rotor speed of approximately 1800 rpm and should be kept in motion until injected.

MIXING PROCEDURES
(SEE END STICKER ON US GROUT BAG FOR TYPE DESIGNATION)
TYPE SD GROUT
1. Meter water into mixer.
2. Add dry grout.
3. Mix at full speed for three minutes.
4. Discharge from mixer.
TYPE ND GROUT
Add appropriate superplasticizer in accordance to project mix design. Consult the project engineer for specified mix ratio.
TYPE VX GROUT
USG Super liquid plasticizer logoVX type grout is to be used with USG-Super liquid plasticizer in accordance to project mix design. Consult the project engineer for specified mix ratio.
NOTE: This grout is thixotropic and should be KEPT IN MOTION until injected.
CAUTION: Although this grout is non-hazardous and environmentally friendly, it contains Portland cement. Exposure to wet grout can cause irritation of eyes and skin. Skin contact should be washed with water. If wet grout or dry grout dust contacts the eyes, they should be flushed with copious amounts of water for at least 5 minutes.

 

1100 Hercules Ave., Suite 320, Houston, TX 77058

CEMENTITIOUS GROUT SALES OR INFORMATION

Contact Avanti International:
1 (800) 877.2570
1 (281) 486.5600